Tree Removal
Dead, leaning, storm-cracked or in-the-way trees taken down in sections and hauled off, with the yard raked out behind us.
Most removals land between $250 and $4,500, driven by height and access.
Tree removal, storm cleanup, lot clearing and dead pine removal for Glennie, Alcona Pond and Vaughn Lake, from an owner-operated crew based in Lupton.
Glennie is Huron National Forest country in Curtis Township, Alcona County, with Alcona Pond and Vaughn Lake at its center and hunting camps and cabins scattered through the pines between them. The trees here are jack pine and red pine on the sand, red oak and aspen on the better ground, cedar along the pond and the lake shores, and ash in the low spots that has mostly died. We cover Glennie for tree removal, dead tree removal, lot clearing, stump grinding and storm cleanup. Call (989) 305-9731 for a free estimate.
Alcona County was one of the counties under the state emergency declaration for the ice storm of March 28 to 31, 2025. Ice loaded the pines and the hardwoods until they broke, power was out for weeks in places, and hundreds of thousands of acres of forest were damaged across northern Michigan. Around Glennie, that means there are still cracked leaders, hanging limbs and half-broken tops sitting in the trees over camps and cabins. Those hangers do not come down on their own on a nice day; they come down in the next wind. If your camp has ice-storm damage still in the canopy, call (989) 305-9731 and we will take it out from the bucket.
Most of the work in Glennie is for camp and cabin owners: a dead red pine leaning toward the roof, a lot to clear for a new cabin or a wider drive, storm wood to buck up and haul off. We clear the building site, chip the brush, and grind or pull the stumps so the site is ready. A large share of the places around Alcona Pond and Vaughn Lake are seasonal, so we are used to quoting from photos and working while the owner is away.
Oak wilt is confirmed in neighboring counties, and the DNR no-prune window for oaks is April 15 to July 15 statewide, so we keep oak trimming around Glennie to the dormant season. Emerald ash borer has been through the whole state, and dead ash in the lowlands is brittle enough that we take it down from the bucket, not by climbing. Dead jack pine and red pine are the same story: fine for a year, then dropping tops.
Lots on Alcona Pond and Vaughn Lake are within 500 feet of the water, so stump grinding or grading can require a soil erosion permit from Alcona County. We check before we quote. Every stump grind gets a MISS DIG 811 locate, which takes three business days. If a tree is on the wire from the pole to the cabin, we arrange a temporary disconnect with your utility before we cut; under Consumers Energy's rules that service drop is the homeowner's responsibility, and the other utilities up here work much the same way.
Getting there
Glennie is about 40 minutes from our home base in Lupton, up through Hale and M-65. It is beyond the 25-mile mark where a travel fee can apply, but we come out for removals, storm work and lot clearing, and we group Glennie jobs together where we can.
Dead, leaning, storm-cracked or in-the-way trees taken down in sections and hauled off, with the yard raked out behind us.
Most removals land between $250 and $4,500, driven by height and access.
Trees on roofs, across drives and hanging in the crown, cleared safely after wind, ice and wet snow. We answer the storm line.
Storm and after-hours work runs 25 to 50 percent above scheduled rates.
Building sites, driveways, lake views and the overgrown back forty cleared, stumps ground, debris chipped or hauled.
Lot clearing typically runs $1,500 to $6,000 per acre.
Dead ash, wilt-killed oaks, hollow maples and leaning pines taken down before they come down on their own.
Dead and hazard tree removals price like any removal: $250 to $4,500.
Everything else we do is on the services page, and the typical ranges are on the pricing page.
Call (989) 305-9731 or send photos. Estimates are free and you hear back within 24 hours.
Having trouble? Reload the page
A new version of the site is available. Please reload to get the latest.